starting eb7001

Discussion in 'Lawn Mowing' started by snapper, Jul 22, 2004.

  1. snapper

    snapper LawnSite Senior Member
    Posts: 399

    Trying to figure out what technique works best. What is your alls technique for cold starting?
     
  2. ElephantNest

    ElephantNest LawnSite Bronze Member
    from La.
    Posts: 1,878

    Cold, or warm...start it the same way: 3-5 pumps of the primer, throttle FULL, choke ON, pull once. Turn choke OFF, pull and should start, occassionally needs one more pull. Make sure to be quick throttling it down as soon as it starts.
     
  3. 65hoss

    65hoss LawnSite Fanatic
    Posts: 6,360

    I never prime them. If I do they flood out immediately. Mine, I just choke it and pull. 2nd pull they start every time. Warm or cold.
     
  4. greasy_gun

    greasy_gun LawnSite Senior Member
    Posts: 334

    3-5 pumps of the primer, full choke...
    starts 2nd pull...
    go to half choke for a few seconds.....
    choke off.....
    good to go
     
  5. ElephantNest

    ElephantNest LawnSite Bronze Member
    from La.
    Posts: 1,878

    If I start mine any way besides how I described it, they both run like crap for a few minutes. So bad that I brought it in for repair, and he showed me how he starts them, and they've been fine ever since.
     
  6. tx_angler

    tx_angler LawnSite Senior Member
    Posts: 278

    What ElephantNest said,
    werks every time for me
     
  7. vipermanz

    vipermanz LawnSite Bronze Member
    Posts: 1,773

    4-6 primes,1/3 throttle, full choke, 2nd pull. always
     

Share This Page