Still new to landscaping tell me what you think

Discussion in 'Original Pictures Forum' started by Mow It All, Jul 20, 2006.

  1. Mow It All

    Mow It All LawnSite Member
    Posts: 22

    Please be honest so I can continue to grow. I juat bought a company going out of uisness with 51 accounts. I have since then picked up 2 apartment complex's and an office building

    resized4.JPG

    resized2.JPG

    resized5.JPG

    resized7.JPG

    resized1.JPG
     
  2. LawnInOrder

    LawnInOrder LawnSite Senior Member
    Posts: 398


    WHat mower or mowers are you cuttin with? LawnInOrder
     
  3. Mow It All

    Mow It All LawnSite Member
    Posts: 22

    Im using a 52" Toro Z Master 149 on the igger stuff, and a 48" Bobcat walkbehind on the smaller. I dont have a stripping kit cause the only ones I saw were strips of rubber......seems usless.
     
  4. NEPSJay

    NEPSJay LawnSite Senior Member
    Posts: 492

    other than the trash and/or leaves in the second pic, the lack of edging along the driveway in the third pic, all the bare spots in the forth pic, and the weeds in the sidewalk cracks in the last one, it looks average.
     
  5. JCP Crafts

    JCP Crafts LawnSite Member
    Posts: 64

    Are your blades sharp ?
     
  6. martinfan06

    martinfan06 LawnSite Senior Member
    Posts: 631

    Looking good man.... Keep up the good work.
    -Jason
     
  7. Mow It All

    Mow It All LawnSite Member
    Posts: 22

    Those are gator blades. I bought 4 sets that I put a sharp set on each morning.
     
  8. dvmcmrhp52

    dvmcmrhp52 LawnSite Platinum Member
    from Pa.
    Posts: 4,205



    Edging along blacktopped driveways is not necesarily a good idea, there is seldom a clean edge to be had.


    If you're just starting out I'd say you have a good start.
    Two things to be succesful, Quality and customer service...........
    Oh ya, did I mention customer service and quality?
     
  9. J&R Landscaping

    J&R Landscaping LawnSite Fanatic
    Posts: 5,096

    Looks good! Keep it up, with work like that, your name will get out there!
     
  10. N&CLandscaping

    N&CLandscaping LawnSite Senior Member
    Posts: 360

    Not Bad Man. The grass to me looks a little too short, what hight were you using when you cut it? I usually use a 3" height. Good Though! Keep it up! Try not doing criss crossed lines though, I found it looks better just cutting it one way.
     

Share This Page