Stump The Technician,,,Name That Tool

Discussion in 'Mechanic and Repair' started by piston slapper, Oct 26, 2012.

  1. Restrorob

    Restrorob LawnSite Fanatic
    Posts: 11,024


    Well.....I googled my dam fingers off for over a hour cuz I couldn't believe I seen 1840, And I thought 1921 was old......
     
  2. 44DCNF

    44DCNF LawnSite Bronze Member
    Posts: 1,459

    Yes sir!

    10characters
     
  3. piston slapper

    piston slapper LawnSite Platinum Member
    Posts: 4,240

    Too bad antique tools don't bring the same value as antique furniture...

    This tool was not designed as a ratchetwrench...it was just what it says..a ratchet..
    The sockets were made to fit into either end...kinda bulky...
    Well...RestroRob...you did the work...researched the patent number....
    See if I can spice up those cyber ribs and add a little flavor to them....
     
  4. piston slapper

    piston slapper LawnSite Platinum Member
    Posts: 4,240

    4 in a row....amazing...didn't think anybody would get #2...
    Its a GM factory tool....a ratcheting flarenut wrench..or a Line wrench as we call them down here..
    Guess you'll have to put that cyber chinese food down ...put on your bib..and dig into a sticky rack of slow smoked BBQ Cyber ribs..:drinkup:
     
  5. piston slapper

    piston slapper LawnSite Platinum Member
    Posts: 4,240

    This tool deserves a closer look...
    I'm still wondering why SnapOn doesnt sell these....

    IMG_0290.JPG
     
  6. piston slapper

    piston slapper LawnSite Platinum Member
    Posts: 4,240

    Do you know why these sockets were modified..???

    IMG_0291.JPG
     
  7. Patriot Services

    Patriot Services LawnSite Fanatic
    Posts: 12,446

    Ill take a stab at #2 custom thinwall for recessed heads they didn't think anybody would have to remove, low torque only please. #3 is notched out for removing sensors without clipping the wires, just in case your not replacing it.
    Posted via Mobile Device
     
  8. piston slapper

    piston slapper LawnSite Platinum Member
    Posts: 4,240

    Looks like you guys need a hint...They could fit almost anything...
    Think...DixieChopper wheelmotor...
     
  9. Richard Martin

    Richard Martin LawnSite Fanatic
    Posts: 14,700

    Been riding around on one going on 12 years now, I don't have a clue. I've never removed a wheel motor from my Dixie. :cool2:
     
  10. piston slapper

    piston slapper LawnSite Platinum Member
    Posts: 4,240

    The bolts on the sides of the wheelmotor are almost against the wheelmotor..
    I've ground wrenches..tried crowsfoots,,,jammed a screwdriver between the nut and the motor (which actually works pretty well)...And then I butchered that socket....Bingo....

    IMG_0297.JPG

    IMG_0298.JPG
     

Share This Page