Stump The Technician,,,Name That Tool

Discussion in 'Mechanic and Repair' started by piston slapper, Oct 26, 2012.

  1. Restrorob

    Restrorob LawnSite Fanatic
    Posts: 11,024


    Slapper...... Yer move'n a little too fast for us Ole timer's......
     
  2. piston slapper

    piston slapper LawnSite Platinum Member
    Posts: 4,240

    Day off tomorrow...figured id go ahead and post the solution....
    I knew that you knew the answer....you speak fluent DixieChopper...
    Not as many Dixie techs as there used to be....
    I still haven't found a good allen socket that works on all the wheelmotors...
     
  3. Restrorob

    Restrorob LawnSite Fanatic
    Posts: 11,024


    Ahhh...... I break them loose with a standard allen wrench with a deep 1/4" socket and extension for a cheater bar, Then use a ball tip hex in my 3/8" impact wrench to run um on out..... Re-install the same way.....

    [​IMG]
     
  4. piston slapper

    piston slapper LawnSite Platinum Member
    Posts: 4,240

    I thought that because SnapOn warranteed the ball allen sockets...you could just pop it on your impact or breakerbar and wrench it off....I snapped a bunch of them...
    The allen socket in the pic used to be a ball end...got tired of warrantying them...

    The other socket in the pic was tapered to remove the bypass hose fitting between the high pressure hoses on the hydropump..

    Incedentally the patent date on the RATchete according to the patent office is May 5 1857....
     
  5. piston slapper

    piston slapper LawnSite Platinum Member
    Posts: 4,240

    Well....I gave you Ole timer's a day off...and a chance to take you meds...catch your breath ..and rest your keyboard finger....

    Let's see what we can come up with tomorrow.....:waving:
     
  6. BigFish

    BigFish LawnSite Silver Member
    Posts: 2,925

    Can ya tell which one is the Polish verniers?

    #1 003.JPG

    #2 006.JPG

    #3 012.JPG

    003.JPG

    006.JPG

    012.JPG
     
  7. Restrorob

    Restrorob LawnSite Fanatic
    Posts: 11,024

    Fish..... Trick question ??? It's kinda obvious since #3 has "Made in Poland" on it, Maybe you should have flipped it over..... ;)
     
  8. piston slapper

    piston slapper LawnSite Platinum Member
    Posts: 4,240

    Seldom used factory tools...

    IMG_0299.JPG
     
  9. kymowboy

    kymowboy LawnSite Member
    Posts: 63

    Crank bushing pullers and valve seat pullers.
    We used to pull the seats before melting the cylinders down, now just pile them in a basket and the seats and dowels are captured and the aluminum flows back into the furnace.
     
  10. piston slapper

    piston slapper LawnSite Platinum Member
    Posts: 4,240

    Well....Lets see...You got 1 right...and 1 wrong...
    Hint...one is a Briggs tool...and one is a Kohler tool..
     

Share This Page