Stump The Technician,,,Name That Tool

Discussion in 'Mechanic and Repair' started by piston slapper, Oct 26, 2012.

  1. BigFish

    BigFish LawnSite Gold Member
    Posts: 3,165

    Man! I thought you were gonna show us a nice Bridgeport.
     
  2. Restrorob

    Restrorob LawnSite Fanatic
    Posts: 11,024

    Not worth the cost just to skin a little off a head once in awhile.....




    Wasn't that the idea ??? :laugh:


    OK....... I bent the shaft on a Briggs starter years ago trying to drive a rusted roll pin out, Never bent another.....


    [​IMG]


    The bend is right on one of the large holes, This lets the roll pin go on through and drops on your bench.

    As you can see here by the mushrooming, It's removed hundreds of starter drives......

    [​IMG]


    Oh...... The starter brush holder Kohler sells, I made one years before and mentioned it at a update..... Suddenly they offered one..... [​IMG]
     
  3. piston slapper

    piston slapper LawnSite Platinum Member
    Posts: 4,240

    The ole starter drive rollpin removal tool....Yep....Briggs would have stolen it from you....
    I too made a starter brush holder. Tool #1 in the first post in this thread...i made it from instructions in a Kohler manual....
    Guess i know where to send the royalty check....watch your mailbox...
     
  4. piston slapper

    piston slapper LawnSite Platinum Member
    Posts: 4,240

    Here's a few more...should be pretty simple..????

    IMG_0264.JPG
     
  5. piston slapper

    piston slapper LawnSite Platinum Member
    Posts: 4,240

    The tool in question is the bolt with all the washers on it....
    Hint...Used alot on Kaw FB460 engines....
     
  6. Breezmeister

    Breezmeister LawnSite Bronze Member
    Male, from South Jersey
    Posts: 1,532

    I will hazard a guess, it looks like a tool I made for removing/installing the piston pin on 23 cc 2 cycle engines, only bigger.
     
    ericg likes this.
  7. piston slapper

    piston slapper LawnSite Platinum Member
    Posts: 4,240

    C'mon Breez.....FB460V Kawasaki engine tool.....comprende'...????:waving:

    Pray for this country...4 more years of the same may be game ...set...match...:confused:
     
  8. Breezmeister

    Breezmeister LawnSite Bronze Member
    Male, from South Jersey
    Posts: 1,532

    The last time I worked on a fb460 was way back in 96, I had to peen a valve seat back in. These where such a rock solid engine if you took care of them.

    Amen !
     
    ericg likes this.
  9. piston slapper

    piston slapper LawnSite Platinum Member
    Posts: 4,240

    You were in the right area...Breez...

    I use that bolt with washers to reposition the valve guides..
    Those engines run so long that the guides like to slip after a few years.
    I just push them back into place..never had one slip twice...

    IMG_0265.JPG
     
  10. Patriot Services

    Patriot Services LawnSite Fanatic
    Posts: 12,695

    Didn't have those problems with seats and guides when there was a little lead in the fuel.
    Posted via Mobile Device
     
    ericg likes this.

Share This Page