Super Z Wont Run while Levers are not in Park Position

Discussion in 'Hustler Turf Equip (Archived)' started by piper5314, May 6, 2012.

  1. piper5314

    piper5314 LawnSite Member
    Posts: 0

    Yesterday, my mower quit. Starts right up, but when I move the steering levers out of park position engine shuts off.

    All three relays under the switch plate seem to be working. I even swapped them around to different positions in case one went bad. Still NO CHANGE!

    Also, after I start it up, if I leave the levers in the PARK position, and engage the blade switch, it also goes dead.

    Any help appreciated!

    Marty
    2006 Super Z
    Kohler 25hp
     
  2. mowerconsultant

    mowerconsultant LawnSite Fanatic
    Male, from Syracuse, NY
    Posts: 9,760

    From what your describing it sounds like your seat switch is either faulty or the wiring going to it has a issue.

    Pj
     
  3. slimjim1985

    slimjim1985 LawnSite Member
    Posts: 2

    BAD SAFETY SWITCH:cool2:
     

Share This Page