Synthetic grease...

Discussion in 'eXmark' started by pryker, Jun 11, 2004.

  1. pryker

    pryker LawnSite Member
    Posts: 56

    Is it ok to use Amsoil synthetic NGLI #2 on a Lazer Z 60"? Will it not mix properly with the grease that is already in the grease fitting?

    Thanks
     
  2. eXmark

    eXmark Manufacturer / Sponsor
    Posts: 4,258

    Pryker,

    About all you can do is to contact Amsoil and ask them if this grease is compatible with the following:

    Mobil XP222 standard, which is used in all pivot points and caster pivots.

    We use Mobil CM-W in the caster wheels because it is a little "thinner" and flows to the bearings better.

    Amsoil should be able to then look up the specs on and tell you if they are compatible. Many of the grease suppliers have charts that show compatibility and should be able to get you fixed up ASAP.

    Personally I don't think it's much of an issue if they are not compatible on the any of the pivot points. I would be concerned about the caster pivot but only slightly. The wheel bearing is a totally different matter. That one I'd be a little more concerned about.

    Thanks

    Terry
     

Share This Page