Techumseh Govenor Diagram

Discussion in 'Homeowner Assistance Forum' started by Shortman, Jul 26, 2007.

  1. Shortman

    Shortman LawnSite Member
    Posts: 2

    Anyone, I have rebuilt a techumseh 6.5 h.p horizontal engine. bought new govenor springs, and rod hook ups, that I lost, and I cannot get them hooked up right. Does anyone have instruction on how to get a diagram of the govenor hook up, or a picture of it. It is on a craftsman high weed trimmer. This is the # on the engine shroud,143.996516, engine family WTPX.1951ba. If someone could give me a site or something to show me just a picture would be all I need. thanks in advance for your help and time.
     
  2. LarryF

    LarryF LawnSite Bronze Member
    Posts: 1,171

  3. Shortman

    Shortman LawnSite Member
    Posts: 2

    :clapping: That was exactly what I needed Larry. I'm brand new here and this is my first post in needing help. What a site and very impressed with quick response. Thanks again for I had searched everywhere until I joined this site.
     
  4. LarryF

    LarryF LawnSite Bronze Member
    Posts: 1,171

    Yeah, I've been there too. Your welcome, and I'm glad it helped.
     
  5. I'll try anything

    I'll try anything LawnSite Member
    Posts: 4

    hey my name is robert i'm working on a old mower from what i can tell it is like a 94 ran really good i just need to figure out how the linkage on the carbeurator hooks up you are the only one to have found anything close with the manuel you sent that guy thing you could help
     

Share This Page