Tecumseh governor setup

Discussion in 'Mechanic and Repair' started by samjdmosher, Aug 9, 2011.

  1. samjdmosher

    samjdmosher LawnSite Member
    Posts: 10

    Does anyone out there have a 6-12hp (prefer 9hp) Tecumseh horizontal shaft engine that they can take a picture of the governor and throttle linkage? I just picked one up that someone was "working on" and they had the carb apart and bent the !$%$! out of all the linkage in the process. Now it doesn't make sense how it goes back together because when it's connected, the only way I can figure out how to, it has to over-center the connection to the throttle shaft to get back to idle.

    Of course any help is greatly appreciated. The actual engine model is a OHM90-222307B. I scoured the inter-web and found exploded parts diagrams galore but that doesn't help for reassembly after the fact.
     
  2. dutch1

    dutch1 LawnSite Silver Member
    from Jayhawk
    Posts: 2,231

  3. samjdmosher

    samjdmosher LawnSite Member
    Posts: 10

    Thank you, that gave me some more clues but it didn't quite fill the gap that I need. Very close diagrams but mine must be just a bit newer.
     

Share This Page