Toro 44" Proline won't move

Discussion in 'Mechanic and Repair' started by tinylang03, Dec 2, 2013.

  1. tinylang03

    tinylang03 LawnSite Member
    Posts: 1

    I was using my Toro 44" Proline belt-drive the other day for one last cut before winter when the wheels stopped driving. I didn't hit anything, the engine was still running, blades still engaged, just the wheels stopped. If I let the mower idle, the shaft off the transmission will rotate, however when I go to push on the T-bar to move the mower forward (no matter which gear 1, 2, 3, or 4) or reverse, no force transfers to the wheels. The traction belt is still connected to the clutch and pulley. Is my transmission shot? I don't want to pay $500 + for a new transmission on an older mower.
     
  2. BigFish

    BigFish LawnSite Silver Member
    Posts: 2,920

    Take another look-see under the unit. You'll prolly find the trans. drive belt has jumped off the idler, or the idler spring is broken( if it has one), or mayhaps the idler needs adjusting to increase the tension on the belt. Could also be the trans pulley is shot.
     

Share This Page