1. Missed the live Ask the Expert event?
    Not to worry. Check out the archived thread of the Q&A with Ken Hutcheson, President of U.S. Lawns, and the LawnSite community in the Franchising forum .

    Dismiss Notice

toro/exmark z wont start except by jumping solenoid

Discussion in 'Mechanic and Repair' started by 44toroz, Apr 20, 2009.

  1. tampatech

    tampatech LawnSite Member
    from Tampa
    Posts: 1

    so.... what did the shop find?
  2. ricky86

    ricky86 LawnSite Bronze Member
    Posts: 1,840

    Hey slick, too bad you brought it to those "sob's". I could have supplied you with test procedures for the motion switches and control module. You know why?? Because I'm one of those "sob's". You ask for help then insult probably the only people who can help you.
  3. xdamxincx

    xdamxincx LawnSite Member
    Posts: 21

    im just wondering if you can seperatly install a push button switch out side of the normal wiring and ignition switch.. assuming that the ignition switch can take away the power to the coil when turned off ?
  4. mowerknower

    mowerknower LawnSite Senior Member
    Posts: 766

    Yeah, me too. There are a lot of people that work at dealerships that post on here. They are usually the ones with legit answers and access to manufacturers info. So be careful who you call and SOB. You might not get help any more.

Share This Page