1. Missed the live Ask the Expert event?
    Not to worry. Check out the archived thread of the Q&A with Ken Hutcheson, President of U.S. Lawns, and the LawnSite community on the Franchising Forum.

    Dismiss Notice

Toro g3 29hp kawi won't crank

Discussion in 'Mechanic and Repair' started by american dream, Nov 30, 2012.

  1. american dream

    american dream LawnSite Senior Member
    Posts: 286

    Will give it a try thanks
    Posted via Mobile Device
     
  2. grasscutter24

    grasscutter24 LawnSite Member
    Posts: 148

    Hopefully it works for you
     
  3. american dream

    american dream LawnSite Senior Member
    Posts: 286

    If I am getting a click could I have a bad starter relay or ignition switch
    Posted via Mobile Device
     
  4. american dream

    american dream LawnSite Senior Member
    Posts: 286

    UPDATE........ thanks to my wife for going through the owners manual I was alerted to the fact that all the safety switches are able to be checked through the ignition module.I was very quickly able to determine that the brake safety was not working because the grommet that holds it in place broke and was not quite holding it in the rite spot.
     
  5. grasscutter24

    grasscutter24 LawnSite Member
    Posts: 148

    Good at least it's an easy fix. Check to make sure that the brake lever you pull up that hits the safety switch isn't bent a little from wear and tear. If so, you will end up breaking the switch again. ( Been there done that). I keep an extra one in the truck since they are cheap to get anyways.
     
  6. american dream

    american dream LawnSite Senior Member
    Posts: 286

    Now onto my clutch prob on the 52,any y'all good with cluches?
    Posted via Mobile Device
     
  7. Monroe74

    Monroe74 LawnSite Senior Member
    Posts: 322

    Turn key on but don't start engine clutch should engage if not pull the electrical plug from clutch and see if you have 11-12 volts if you get new clutch if not problem is on mower
     
  8. american dream

    american dream LawnSite Senior Member
    Posts: 286

    I looked under the mower and it looks like all the wires got ripped loose and the whole clutch asymbaly is now free spinning is there supposed to be something to keep this from spinning?
    Posted via Mobile Device
     
  9. Monroe74

    Monroe74 LawnSite Senior Member
    Posts: 322

    A bracket is supposed to be there
     
  10. american dream

    american dream LawnSite Senior Member
    Posts: 286

    I can not find a bracket anywhere
    Posted via Mobile Device
     

Share This Page