Toro Proline 37" recycler

Discussion in 'Mechanic and Repair' started by Lawnstar, Feb 23, 2005.

  1. Lawnstar

    Lawnstar LawnSite Member
    Posts: 52

    I have a Toro 37" 12.5 Kawa. gear drive walk behind. The mower is going
    seven years old. Over the years I have adjusted the control arms by taking the hair pin cotter and turning the control rods. The t-bar is pinching my fingers. I'm wondering is there some other type of adjustments I can do or is it the two large drive belts that need to be replaced? I have all the manuals that came with the mower and that are useless in helping me on this.

  2. Lawnstar

    Lawnstar LawnSite Member
    Posts: 52

  3. BillyDay

    BillyDay LawnSite Member
    Posts: 3

    I also have a toro 37" recycler about the same age. I had a similar problem and replaced the 2 large belts and the 2 small drive pulleys. It is amazing how much wear these small drive pulleys get. I also had to replace the 2 small drive pulley bearings. Hope this isn't too late and that it helps.
  4. LawnScapers of Dayton

    LawnScapers of Dayton LawnSite Silver Member
    Male, from Dayton, OH
    Posts: 2,574

    start with replacing the belts.......


Share This Page