Toro/Suzuki 2- cycle Starting Problems

Discussion in 'Mechanic and Repair' started by argy11, Jul 22, 2005.

  1. argy11

    argy11 LawnSite Member
    Posts: 1

    Need help!! Have been unable to get my Toro Model:26682 started.
    It has the Suzuki 2 Cycle Engine... have replaced plug, filters, and all the obvious items... .. Neighbor said it could be the timing?? Can anyone advise me how to set the timing on this mower... I hate to give up on her.
    Did check the flywheel key and it is ok.. Sometimes when I pull the rope , she jerks out of my hand,, but no start.
    Grateful for any guidance.
     
  2. Restrorob

    Restrorob LawnSite Fanatic
    Posts: 11,022


    I use to own one of these units years ago and didn't remember anything that could be out of time, So I went to the parts break-down and looked the engine over and there isn't much to it at all. If you checked the flywheel key and it's ok all thats left is the coil air gap. Check this with any business card,If it's ok I believe all it could be is a bad coil.
     

Share This Page