Toro z400

Discussion in 'Mechanic and Repair' started by njlawnmower, Nov 1, 2009.

  1. njlawnmower

    njlawnmower LawnSite Member
    Posts: 1

    Hello, I am having a problem with the clutch on my Toro zero turn, z400 18hp Kohler engine. I discovered that the bolt on the bottom of the shaft was missing, not sure if it broke off or is just missing. I don't see how to remove the belt pulley and then the clutch to inspect the shaft. Not sure what to do next, any questions or ideas would be helpful. Thanks.
  2. unkownfl

    unkownfl LawnSite Gold Member
    Posts: 3,838

    pulley has jack bolt holes in it most likely.

Share This Page