1. Missed the live Ask the Expert event?
    Not to worry. Check out the archived thread of the Q&A with Ken Hutcheson, President of U.S. Lawns, and the LawnSite community on the Franchising Forum.

    Dismiss Notice

Torque specs?

Discussion in 'Mechanic and Repair' started by Dstosh, Aug 27, 2009.

  1. Dstosh

    Dstosh LawnSite Senior Member
    Posts: 716

    Does anyone have the torque specs for a kawasaki fh721v? 25 hp I bent a valve and am going through the top end. I need specs for Heads (and the sequence to tighten down the bolts and intake, exhaust etc. Thanks

    What are the tolerances for the valves. .003-.005 when cold? at TDC?


    Thanks
     
  2. Restrorob

    Restrorob LawnSite Fanatic
    Posts: 11,024

    Head;

    [​IMG]

    Intake; 52 in.lbs.

    Exhaust;

    [​IMG]


    You are correct on the valves.


    Good Luck......
     
  3. Dstosh

    Dstosh LawnSite Senior Member
    Posts: 716

    Thanks rob. Couldn't do it with out ya!
     
  4. Restrorob

    Restrorob LawnSite Fanatic
    Posts: 11,024

    [​IMG]
     

Share This Page