1. Missed the live Ask the Expert event?
    Not to worry. Check out the archived thread of the Q&A with Ken Hutcheson, President of U.S. Lawns, and the LawnSite community on the Franchising Forum.

    Dismiss Notice

trailer gate in the making

Discussion in 'Original Pictures Forum' started by fastcat, Apr 4, 2007.

  1. fastcat

    fastcat LawnSite Senior Member
    Posts: 799

    here are some pics of the trailer gate i am making.

    P1000268(1).JPG

    P1000269(1).JPG

    P1000270(1).JPG
     
  2. fastcat

    fastcat LawnSite Senior Member
    Posts: 799

    see if these look any better. I changed the pic quality.

    P1000268(2).JPG

    P1000269(2).JPG

    P1000270(2).JPG
     
  3. grassmanak

    grassmanak LawnSite Senior Member
    Posts: 792

    take a close of of those welds, they dont look to healthy
     
  4. fastcat

    fastcat LawnSite Senior Member
    Posts: 799

    its just the flux residue all over it. i have to remove it before paint.
     
  5. dcondon

    dcondon LawnSite Silver Member
    Posts: 2,246

    Thats more then just Flex but good idea though:waving:
     
  6. Runner

    Runner LawnSite Fanatic
    Posts: 13,496

    Is that all sq. tubing? Holy SMOKE! I hope you have someone to lift that for you!
     
  7. fastcat

    fastcat LawnSite Senior Member
    Posts: 799

    2x2x1/8 angle iron
     
  8. grassmanak

    grassmanak LawnSite Senior Member
    Posts: 792

    what kind of welder are you running and on what setting do you have it??
     
  9. ncls

    ncls LawnSite Senior Member
    Posts: 441

    I've got 3 trailers. One has a double rear gate. Guys fight over it in the morning. It's so much easier with a split gate. Just an idea.
     
  10. fastcat

    fastcat LawnSite Senior Member
    Posts: 799

    I finally found time to post the finished gate pics.

    P1000274(1).JPG

    P1000275(1).JPG

    P1000276(1).JPG

    P1000277(1).JPG

    P1000280(1).JPG
     

Share This Page