1. Missed the live Ask the Expert event?
    Not to worry. Check out the archived thread of the Q&A with Ken Hutcheson, President of U.S. Lawns, and the LawnSite community in the Franchising forum .

    Dismiss Notice

Trailer Sides

Discussion in 'Trucks and Trailers' started by Trevor8, Sep 23, 2010.

  1. Trevor8

    Trevor8 LawnSite Senior Member
    from IA
    Posts: 750

    How should I create trailer sides on my 5x8 trailer because it has a thin tube with wires running through it on the inside of my trailer, which would get in the way of the sides?
  2. mowerbrad

    mowerbrad LawnSite Fanatic
    Posts: 6,273

    Some plywood sides and U-bolts to go around your tube railing?
  3. newjerseylandscaping

    newjerseylandscaping LawnSite Bronze Member
    Posts: 1,175

    dont know if you did it yet but i just cut the bottom of the board at a 45degree angle and it cleared the wire tube. i screwed my to the rails and then the boards at the 2 sides and the front meet, ill try to get some pics up soon, if you do it maby you can snap some pics ?
  4. seabee1

    seabee1 LawnSite Member
    Posts: 239

    hey trevor do you have a picture of what you are talking about i am having a hard time picturing this ? :confused:
  5. newjerseylandscaping

    newjerseylandscaping LawnSite Bronze Member
    Posts: 1,175

    If it is what i think it is its a little pipe that runs along the inside of the trailer floor on the side that is used to run the wires for the lights from the front to the back.

Share This Page