Velke for 36" Viking

Discussion in 'eXmark' started by LawnSharks, Apr 26, 2008.

  1. LawnSharks

    LawnSharks LawnSite Senior Member
    Posts: 300

    Would you recommend a velke/sulky for a 15 hp Kawi 36" Viking? There does not seem to be any mounting holes pre-drilled. Operator weighs about 215-220? Usage will be very low, only about 1 1/2 hours per week on flat terrain.
    Thanks for your input!
     
  2. eXmark

    eXmark Manufacturer / Sponsor
    Posts: 4,258

    LawnSharks,

    There may not be enough holes for the velke, but our Stand-On should fit right on!!

    KC
     
  3. LawnSharks

    LawnSharks LawnSite Senior Member
    Posts: 300

    Would it weaken the plate if I drill a couple of mounting holes? They would be on the same line as I have on the 48" Turf Tracer.
     
  4. eXmark

    eXmark Manufacturer / Sponsor
    Posts: 4,258

    LawnSharks,

    Anytime you drill holes that aren't already there, it will effect the structural integrity of that piece. The Stand-On will slap right on.

    KC
     
  5. LawnSharks

    LawnSharks LawnSite Senior Member
    Posts: 300

    What is the cost of the 2-wheeled stand on?
     
  6. freshprince94

    freshprince94 LawnSite Bronze Member
    Posts: 1,449

    No two wheeled Stand-On
     

Share This Page