Velke X-2, Lesco Sulkey, Accelerator catcher, Truckster spreader, BP spray rack.

Discussion in 'Marketplace' started by Jason Rose, Jun 29, 2008.

Thread Status:
Not open for further replies.
  1. Jason Rose

    Jason Rose LawnSite Fanatic
    Posts: 5,858

    All for sale.

    Velke X-2 sulkey, Basically NEW, used on 2 lawns, literally. Standard set-up with the 18 inch bar, Scag Orange. (I wanted yellow to match my G.Dane, but they only had orange, black, and red). The pivot mount that goes on the mower has NOT even been used. Paid $270.00 with shipping 2 months ago, Make me an offer, and you pay for the shipping. I still have the original box, though I hate to take it completely apart to make it fit back in there...

    [​IMG]
    [​IMG]


    Lesco Sulkey. Came with the Great Dane mower I bought last fall. Very heavy built, also not used much at all. This is the castering type, as you can see, allows you to stay in the same position behind the controls all the time. Everything on it is solid other than the bushing that connects the front U-shaped part to the actual cart, it's pretty wobbly, though maybe it's designed that way??? I've never been on a new one. Again, I know these are pretty expensive new, I can ship this, will have to take it apart somewhat to fit in a box. Buyer pays for actual shipping costs. Make me an offer?

    [​IMG]
    [​IMG]

    Now, This is a Jungle Jims backpack sprayer rack. Never used, never mounted. I bought it to have a 2nd one and found I had no room for it and no use for it on my other trailer. Now I'm tired of it sitting in my way... $50, plus shipping.

    [​IMG]
    [​IMG]

    Lesco "truckster" spreader. Mounts to anything you want to put it on. you just need a 12 volt power source to run the motor that spins the impellor. This has been sitting for a couple years, I cleaned the durt off of it today and confirned that it DOES still work fine. The pull cord open/close works fine, just lube the mechinism liberally and frequently, that's what I always did. Also has a reostat (basically a dimmer switch) so the motor speed can be adjusted. I tried to set it so the spread width was the same as my push spreader, but could also turn it down further to do narrower strips, works great! Bought a Permagreen, have no use for this anymore. $100.00 + shipping.

    [​IMG]
    [​IMG]
    [​IMG]

    Accelerator Catcher, basically brand new, used on a half dozen lawns at best. Model GCDN, comes with the angle bracket for decks that don't have a place to drill the hole for the catcher 'pin' to fit into. The rubber flap on the back side of the opening is my addition. I missed my alignment with the hole a little and did that to prevent blowout. It can be removed or trimmed as needed.
    Fits: Dane 36,48,52, inch decks (except 36 surfer)
    also fitsSnapper midsize
    ALL 52" Decks- all models

    $250 + shipping.

    [​IMG]
    [​IMG]
    [​IMG]
     
  2. coryc_23

    coryc_23 LawnSite Member
    Posts: 82

    I was wondering what it would cost to ship that to 43078 in urbana oh. i would give you the 100 that you where asking if the shipping wasn't to high thanks cory.
     
  3. Jason Rose

    Jason Rose LawnSite Fanatic
    Posts: 5,858

    I'll have to check as soon as I can. Need to get a weight on it then I can hopefully calculate pretty close.
     
  4. metro36

    metro36 LawnSite Silver Member
    Posts: 2,412

    How would you work out payment for one of the sulkys. I could use either one. Also will that catcher fit a lesco fixed deck? Thanks
     
  5. Jason Rose

    Jason Rose LawnSite Fanatic
    Posts: 5,858

    I can take payment through pay pal or a certified check from your bank.

    With your 36" hydro I'd suggest the velke X-2. I know my 48" hydro walkbehind strugled to turn and back the lesco one because of it's weight. But it's your call, maybe the Lesco mowers have ore weight in the back end, more traction, than my great dane?
    As for the catcher I have listed what model it is and what it will fit, I'm unsure how close it would be to the lesco opening, you could ask accelerator to find out.
     
  6. metro36

    metro36 LawnSite Silver Member
    Posts: 2,412

    Let me look into the catcher and I will let you know. thanks
     
  7. Jason Rose

    Jason Rose LawnSite Fanatic
    Posts: 5,858

    Bump to the top!

    Spreader may be sold, it's boxed and ready to get a shipping quote.

    Velke X-2 is in it's box and ready to ship, someone buy it, brand new (almost) heck of a deal!

    Everything else still for sale as well.
     
  8. JosephLawnCare

    JosephLawnCare LawnSite Senior Member
    Posts: 809

    Shipping price for the bagger to 43054. thanks
     
  9. Jason Rose

    Jason Rose LawnSite Fanatic
    Posts: 5,858

    Well, people are absolutely insane. The box needed is 20x20x40 and the weight would be about 25 pounds. The price I was quoted you would think I was trying to ship a crate of gold bars.

    Yeah, they want $133.65, and that's not including the almost $10 they want for a box that big...
     
  10. Jason Rose

    Jason Rose LawnSite Fanatic
    Posts: 5,858

    Shipping $42.91 to you.
     
Thread Status:
Not open for further replies.

Share This Page