Veneer stone interior installation

Discussion in 'Hardscaping' started by jeffslawnservice, Feb 17, 2013.

  1. jeffslawnservice

    jeffslawnservice LawnSite Senior Member
    Posts: 830

    Previously when installing veneer stone it was new construction and we installed cement board instead of drywall. For this one its drywall, paint, and wall paper. My question is can I pull off the paint and wall paper, install metal lath, scratch coat and then the veneer or do I need to pull off the drywall and install cement board?
    Posted via Mobile Device
     
  2. OSdb

    OSdb LawnSite Member
    Posts: 75

    Tar paper,lath then scratch coat-
     
  3. jbailey52

    jbailey52 LawnSite Bronze Member
    Posts: 1,061

    Here is a job I just did on my office... I applied it directly to the painted drywall using a expensive tile adhesive (specifically for tiles on to be installed on the floor and walls). Dont know if this is up to construction spec, but I had to remove a couple tne next day... and the drywall came right with it. Before I installed the stone, I did screw probably 50 drywall screws through the drywall to secure it better to the studs so the weight of the stones did not rip the drywall away from the studs.


    Dont mind the outlet... still need to make that look better.
    Also if your going to install lath, then there is no need to remove the wall paper and paint
    [​IMG]
     
    Last edited: Feb 18, 2013

Share This Page