1. Missed the live Ask the Expert event?
    Not to worry. Check out the archived thread of the Q&A with Ken Hutcheson, President of U.S. Lawns, and the LawnSite community in the Franchising forum .

    Dismiss Notice

walker blower replacement question

Discussion in 'Mechanic and Repair' started by bligh61, May 21, 2008.

  1. bligh61

    bligh61 LawnSite Member
    Posts: 239

    I have replaced the blower a few times on my 20hp walker, any shortcuts that you know of? I have jacked up the rear and removed and replaced via that route and it stinks. Is there an easier way? Can I remove any of the frame to make it easier, or the engine? thanks
  2. KS_Grasscutter

    KS_Grasscutter LawnSite Gold Member
    Posts: 3,332

    Just jack up/lift up the back end about a foot or so, then undo like 6 or 8 bolts and it should slide right out of there. There is the one bracket on the bottom of the blower that has to come off, if i recall right. Just be sure to NOT overtighten the little nuts and bolts, because they DO break real easy lol.

Share This Page