What setting for spreading 46-0-0 Eurea?

Discussion in 'Pesticide & Herbicide Application' started by David W, Nov 7, 2006.

  1. David W

    David W LawnSite Senior Member
    Posts: 282

    I use Earth Way spreaders with pneumatic tires (2150 to be exact) and I am trying to figure out what setting to spread 1# N per 1,000 sq ft?

    I have been searching past posts and finally gave up. What settings do you guys use who fert with Earth Way spreaders or even Lesco as I seen they are close in number settings?

    I want to make sure I get this fert down right, especially using 46-0-0.

    Thanks
     
  2. dcgreenspro

    dcgreenspro LawnSite Senior Member
    from PA
    Posts: 688

    calibrate it yourself but remember that stuff is HOT:blob2:
     
  3. LonniesLawns

    LonniesLawns LawnSite Senior Member
    from KS
    Posts: 317

  4. David W

    David W LawnSite Senior Member
    Posts: 282

    Yeah I know...if I had time I would.

    Thanks for the link. Interesting read.
     
  5. nate1422

    nate1422 LawnSite Member
    Posts: 108

    I just did my lawn and did a test at 10, it didn't spread well, the gates are not open far enough. I adjusted to 12-13 and it was spreading nice 6 ft pattern but I put down 0.63 lbs/1000.
     
  6. David W

    David W LawnSite Senior Member
    Posts: 282

    Why only .63 # per 1000?

    And was that 12-13 on a EarthWay spreader?
     
  7. lawnangel1

    lawnangel1 LawnSite Senior Member
    from KY
    Posts: 601

    Just eye it! I am totally joking of course.
     
  8. UpNorth

    UpNorth LawnSite Member
    from NE,US
    Posts: 207

    Im with "lawnangel1," Id just eyeball it. Do a couple of lawns see how much is left it he spreader, and make adjustments as needed. Whats the worst thing that could happen, your only using 46-0-0!!!

    Hahahahahahahahahahahahaha!!!!!!
     
  9. David W

    David W LawnSite Senior Member
    Posts: 282

    Yeah right...thanks a lot fellas!

    I know now why they push slow-release fertilizer so much!!!! :)
     
  10. turfsolutions

    turfsolutions LawnSite Senior Member
    Posts: 851

    No time to calibrate? It takes all of 10 minutes. Set it at 12-15 and adjust accordingly. Yes I am talking about Earthway.
     

Share This Page