what size zerk on wright caster wheel???

Discussion in 'Lawn Mowing' started by johnnywill08, Jun 30, 2007.

  1. johnnywill08

    johnnywill08 LawnSite Senior Member
    from MA z6
    Posts: 383

    the manual just says "caster wheel zerk".... not the zerk on the arm but the one on the wheel that greases the axle. its a 52" stander.... obviously i'm talking about the threaded end.

    thanks guys!
     
  2. ed2hess

    ed2hess LawnSite Fanatic
    Posts: 13,317

    I guess it got knocked out....usually I can find only two sizes so I generally get both and put the one in that fits.....may have to weld it to hold in place.
     
  3. tallimeca

    tallimeca LawnSite Bronze Member
    Posts: 1,229

    although not a standard......MOST........ zerk fittings in the ope industry are 1/4 28.
     
  4. XtreemGreen

    XtreemGreen LawnSite Member
    Posts: 17

    yes, most on the mowers are 1/4..
     
  5. johnnywill08

    johnnywill08 LawnSite Senior Member
    from MA z6
    Posts: 383

    thanks guys!
     
  6. Digdug

    Digdug LawnSite Member
    Posts: 125

    johnny - is there not something there still to remove , and copy the size? Also if it fell out it could be a push in zerk , my Walker had some push in zerks. Take the one out of the other wheel and get the same size , maybe?? Good luck, doug
     

Share This Page