Which One of You Yay-Hoos Installed This???

Discussion in 'Irrigation' started by JimLewis, Aug 12, 2010.

  1. JimLewis

    JimLewis LawnSite Fanatic
    Posts: 6,842

    Ok, which one of you Yay-Hoos installed this beautiful piece of work??? Hosk? Was it you?

    Had to pass this on. This is hilarious. It's even funnier because here in Oregon we never install anything above ground. No PVBs, No AVBs, and very rarely even an RP. Pretty much 99% of valves and backflow (DCVA) are all below ground. So to see a mess like this is even less common here than it might be in some of the warmer climates that some of you work in.

    Just awesome though. I love the creative use of water source, valving and wiring. The wiring is especially trick! That's how I knew it must have been one of you "Pros" who did this fine work. It takes a certain level of skill to get this all right....



    .

    MessedUp3.jpg

    MessedUp1.jpg

    MessedUp2.jpg
     
  2. Nice woodwork.
     
  3. Mjtrole

    Mjtrole LawnSite Member
    Posts: 226


    That is the work and/or idea of some type of engineer.
     
  4. Dripit good

    Dripit good LawnSite Bronze Member
    Posts: 1,081

    The use of galvanized gives it a nice touch.
     
  5. DanaMac

    DanaMac LawnSite Fanatic
    Posts: 13,156

    You got me. I installed it on my mom-in-law's place while in Eugene, OR. My bad. :waving:
     
  6. Wet_Boots

    Wet_Boots LawnSite Fanatic
    Posts: 48,017

    I suspect Sheshovel :p
     
  7. WalkGood

    WalkGood LawnSite Bronze Member
    Posts: 1,910

    I bet that union is so it can be disconnected for Winter.
     
  8. irrig8r

    irrig8r LawnSite Platinum Member
    Posts: 4,535

    This is the kind of "solution" I often run across when the homeowner is either an engineer... or a know-it-all DIY... or both.

    Thanks for sharing.
     
  9. AI Inc

    AI Inc LawnSite Fanatic
    Posts: 25,535

    Looks like they wanted to test it before they shipped it cross country.
     
  10. Some Sprinkler Guy

    Some Sprinkler Guy LawnSite Member
    Posts: 167

    I gotta say looks like an engineers work too.

    Too much thought went into putta all this crap together.
     

Share This Page