1. Missed the live Ask the Expert event?
    Not to worry. Check out the archived thread of the Q&A with Ken Hutcheson, President of U.S. Lawns, and the LawnSite community on the Franchising Forum.

    Dismiss Notice

who else makes idley pulleys?

Discussion in 'Mechanic and Repair' started by grass disaster, Sep 27, 2012.

  1. grass disaster

    grass disaster LawnSite Silver Member
    Posts: 2,578

  2. pugs

    pugs LawnSite Gold Member
    Posts: 3,018

    V pulley? Flat pulley? Flat with lips? 5" from flat to flat? 5" to lips? How wide or what series V belt? and the list goes on.

    Oregon or Stens sell lots of pulleys. Most that use reducer bushings have a .669 ID bearing.
     
  3. grass disaster

    grass disaster LawnSite Silver Member
    Posts: 2,578

    Its a V....standard belt. 5/8 belt I think!
    Posted via Mobile Device
     
  4. JimQ

    JimQ LawnSite Bronze Member
    Posts: 1,139

    Try an Oregon 34-106 Pulley

    With either a 78-100 (flush) or 78-102 (1/4" offset) bushing

    or you could try and JB Weld a slightly used (but still good) bearing back in the old pulley. :laugh: :waving:

    Q
     

Share This Page