woodworking with fluid film

Discussion in 'Eureka Fluid Film' started by SKYNYRD, Oct 19, 2009.

  1. SKYNYRD

    SKYNYRD LawnSite Fanatic
    Posts: 10,447

    turned some scrap lumber into sawhorses recently. used fluid film to coat the blade on my table saw to ease the cutting. also used it on the extension slides on the saw and my roller stand:cool2: it def made a difference. in the past when i've ripped a 12' board the saw would smoke cause it was burning the lumber (even with a new blade it would smoke) had no smoking problems at all after the application of ff:weightlifter:

    1.jpg

    2.jpg

    3.jpg

    8.jpg
     
  2. Dano50

    Dano50 LawnSite Bronze Member
    Posts: 1,781

    Thank you once more for some beautiful pics!
     
  3. SKYNYRD

    SKYNYRD LawnSite Fanatic
    Posts: 10,447

  4. JoyofFluidFilm

    JoyofFluidFilm LawnSite Senior Member
    Posts: 438

    well, sure enough, you pleased the heck outta dano...
     
  5. SKYNYRD

    SKYNYRD LawnSite Fanatic
    Posts: 10,447

    that's a good thing:) isn't it joy;)
     
  6. DLAWNS

    DLAWNS LawnSite Fanatic
    Posts: 5,778

    It's been too quiet around here lately! lol
     
  7. Dano50

    Dano50 LawnSite Bronze Member
    Posts: 1,781

    We need to stir it up. Any good contests you guys would like to see?
     
  8. punt66

    punt66 LawnSite Fanatic
    Posts: 8,538

    Just for the record. I have been enjoying the case of FF.
     
  9. Dano50

    Dano50 LawnSite Bronze Member
    Posts: 1,781

    Always nice to hear.:drinkup:
     
  10. punt66

    punt66 LawnSite Fanatic
    Posts: 8,538

    Is FF safe to use in elecrical connections? Such as plow plugs. Trailer plugs.
     

Share This Page