Wright sentar electrical issue

Discussion in 'Mechanic and Repair' started by MARKLYNN, Jun 9, 2014.

  1. MARKLYNN

    MARKLYNN LawnSite Member
    Posts: 2

    I HAVE A 25 HP KAWASKI ON A WRIGHT SENTAR , IT WILL NOT START, IT ACTS LIKE ITS A FUEL PROBLEM, BUT THERE IS FUEL GOING TO THE CARB.. I HAVE REPLACED THE RELAY, AND ENGINE STOP SWITCH , THERE IS NO POWER GOING TO THE SPARK PLUGS , THE SOLENOID IS WORKING FINE, AND THE STARTER IS WORKING WHEN "JUMPED" FROM THE BATTERY .. COULD MY PACS HAVE GONE BAD ?? HELP :cry:
     
  2. dieselss

    dieselss LawnSite Bronze Member
    Posts: 1,630

    How do you know the plugs don't have spark? Why do you have to jump the starter?
    Posted via Mobile Device
     
  3. RickyDL77

    RickyDL77 LawnSite Senior Member
    Posts: 431

    I would start by checking your Zone Safety switches. bypass them 1 at a time and see if it goes to working.
     
  4. WrightCommercial

    WrightCommercial Inactive
    Posts: 526

    MARKLYNN,

    Disconnect the white magneto wire that connects from the engine harness to the mower and try starting the mower, if the mower starts then the presence system is killing the ignition, if it doesn't then the problem is on the engine side. If the Sentar is a later model it will also have a blade delay module which if faulty can cause this issue.

    Best Regards,
    Wright Mfg.
     

Share This Page