Wright Stander engine speed

Discussion in 'Lawn Mowing' started by robertsturf, Jul 18, 2004.

  1. robertsturf

    robertsturf LawnSite Bronze Member
    Posts: 1,405

    I have had a few problems with my 2002 Wright Stander 48" 17hp. dispersing grass .To make a long story short I seem to have figured out that the engine speed needs to be set with the blades on. Does anyone know or recommend what the speed should be set at?
     
  2. EastProLawn

    EastProLawn LawnSite Bronze Member
    Posts: 1,110

    I always run my Wright Stander at full throttle.
     
  3. MacLawnCo

    MacLawnCo LawnSite Bronze Member
    Posts: 1,847

    First, youll need to get a tachometer. Tinytach is a good one as is Sendeck. To answer your question, the RPMs are set to max out at 3750 under load. That way i can vary the engine speed from normal, 3600, under normal conditions upwards depending on what the conditions warant. Only way to do that is with a tach, so get one.
     
  4. Tider6972

    Tider6972 LawnSite Senior Member
    from Alabama
    Posts: 649

    you better service: ie been more accurate / lasted longer?
     
  5. Droffaws

    Droffaws LawnSite Member
    from KCMO
    Posts: 63

    What? I'm not real sure what you've said.

    I'm not trying to be a jerk or anything...just want to know what you're talking about?

    :confused:
     
  6. MacLawnCo

    MacLawnCo LawnSite Bronze Member
    Posts: 1,847

    this year is my first with the tiny tach brand. many here rave about them, but i dont see any difference between it and my sendecks. Both are similarly priced, $40, so go with whatever your dealer has.
     

Share This Page