WTB: Isuzu spray truck (retired trugreen truck)

Discussion in 'Marketplace' started by The Turfinator, Jan 24, 2013.

  1. GaryBK

    GaryBK LawnSite Senior Member
    from Canada
    Posts: 253

    Thanks!
    Posted via Mobile Device
     
  2. DUSTYCEDAR

    DUSTYCEDAR LawnSite Fanatic
    from PA
    Posts: 5,137

    just rip out the old crap and install new stuff they tend to sell the trucks in lots of 10 if you want a deal that is the way to get them.
     
  3. Green Sweep

    Green Sweep LawnSite Senior Member
    Male, from Pittsburgh, PA
    Posts: 322

    Well, we just purchased one. Nice truck - 2004. Everything is operational except for this pump (which I posted pictures of earlier). We are having a hell of a time getting the motor off of the pump... Any suggestions?
     
  4. WestGaPineStraw

    WestGaPineStraw LawnSite Senior Member
    Posts: 763

    Motor probably won't come off. They have them for sale on eBay. Your truck have the big pumps on it too?
    Posted via Mobile Device
     
  5. Green Sweep

    Green Sweep LawnSite Senior Member
    Male, from Pittsburgh, PA
    Posts: 322

    Yes. The pumps to the 200 & 350 gallon tanks are functioning. We put water in the tanks and tested this morning. The pump that is not functioning is not too big of a deal right now. I eventually want to get it to work or get a new one.
     
  6. WestGaPineStraw

    WestGaPineStraw LawnSite Senior Member
    Posts: 763

    I can get you one for $300 eBay sells them for about the same. Great job on getting a functioning one.
    Posted via Mobile Device
     
  7. Green Sweep

    Green Sweep LawnSite Senior Member
    Male, from Pittsburgh, PA
    Posts: 322

    Also wondering what this is for? Found this setup in the spreader/fert storage area. Two solenoids with some kind of key? To the hose reels?

    Whats.JPG
     
  8. Green Sweep

    Green Sweep LawnSite Senior Member
    Male, from Pittsburgh, PA
    Posts: 322

    Thanks! Drove all the way to Chattanooga Tennessee & back for this bad boy! May take you up on the pump. We are going to replace all of the hoses 1st. Buff out the TG logo & get it decaled, then focus on the pump.
     
  9. GaryBK

    GaryBK LawnSite Senior Member
    from Canada
    Posts: 253

    One solenoid for each pump. That allows the high amperage motors to be run by low amperage reel switch buttons. The key would disconnect the power to the solenoids I would assume.
    Posted via Mobile Device
     
  10. WestGaPineStraw

    WestGaPineStraw LawnSite Senior Member
    Posts: 763

    Your right, hose reel solenoid. Your missing the disconnect plug, it's the bottom part in that picture. I would just jump the wires. The reels probably do not roll up at this point.
    Posted via Mobile Device
     

Share This Page