Yes! Another RBG question

Discussion in 'Lawn Mowing' started by Huck, Jun 23, 2001.

  1. Huck

    Huck LawnSite Member
    Posts: 7

    When using these grinders, do you find that holding the blade at an angle to the wheel instead of 90 degrees, creates a better concave look instead of a squared off corner where you stop grinding? thanks,huck :)
     
  2. Eric ELM

    Eric ELM Husband, Father, Friend, Angel
    Posts: 4,831

    I always hold the blade flat on the table when sharpening. This is the way this should be done to be consistant with the angles. Adjust the motor and wheel up or down to get the correct angle to start with.
     
  3. cp

    cp LawnSite Senior Member
    Posts: 263

    I wish I could afford one.

    I'm using a Makita 4 1/2" hand held and I am not very good at it.
     

Share This Page