1. Missed the live Ask the Expert event?
    Not to worry. Check out the archived thread of the Q&A with Ken Hutcheson, President of U.S. Lawns, and the LawnSite community in the Franchising forum .

    Dismiss Notice

Your recommendation for certain blades in certain conditions.

Discussion in 'eXmark' started by GarPA, Oct 20, 2004.

  1. GarPA

    GarPA LawnSite Silver Member
    from PA
    Posts: 2,585

    Much has been talked about here over the years about highlifts, gators, megmo, etc etc.It might be nice to have one thread where we cover different mowing scenarios along with your recommendations. ( I did a search but didn't find exactly what I was looking for here)

    On the hp52 we run factory highlifts most of the year with and without the ultra vac. The cut is very good. We run the mulch kit/w factory mulching blades on the Vikings and the cut is also good.

    What blade set up do you recommend for:
    1. cutting down an overgrown property - grass in excess of 12". Multiple passes then bag it at end of cut down
    2. best set up for mowing with a moderate amount of leaves on turf (mulch kit NOT installed)..no collection of leaves
    3. best set up overall for use with the ultravac

    any other tips/recommendations are appreciated...thanks much
  2. GarPA

    GarPA LawnSite Silver Member
    from PA
    Posts: 2,585

    Terry or whomever from Exmark....
    would appreciate your input on this thread..thanks
  3. eXmark

    eXmark Manufacturer / Sponsor
    Posts: 4,258

  4. GarPA

    GarPA LawnSite Silver Member
    from PA
    Posts: 2,585

    THanks...just what I was looking for
  5. dvmcmrhp52

    dvmcmrhp52 LawnSite Platinum Member
    from Pa.
    Posts: 4,205

    The thread you referenced here is an excellent thread to keep up top as was suggested (I believe in the referenced thread itself)
    Have you figured out how to keep it up top?
    It would be great reference material.

Share This Page