Search Results for ‘dies’

Im from middle ga I have an exmark Lazer z with a 66" deck and 27hp Kohler engine...trouble getting it to run correctly......started while I was mowing. It popped one of the 20amp fuses I tried to trace it back and found nothing. It was blowing when I engaged the PTO. I replaced the PTO switch...

My scag hydro walk behind dies when I engage the deck. The blades move freely. Any thoughts?

Anyone know what my issue could be? It seems to happen if it's been sitting for a while and I start it up. It fires up first pull every time w/o hesitation and roars to life. If it's fine, I will do the yard w/o a single hiccup and everything will be fine. If it acts up about a minute after...

I have a 48'' toro hydro walk behind. Proline deck, Kohler command SP15 engine. The mower itself is an 08 and I dont think any major components have been replaced. Mower model # 30528 Engine Model # CV15T Now to my problem. . . The mower will start revving a little once it goes then it will...

I have a 2008 Scag 36" walk behind (belt driven) with probably 50 hours on it. I've had a few problems in the past with the engine dying when I place the transmission into gear. Some fiddling with the Operator Presence Switch and it seemed to be OK. The other day I just started mowing and...

I have a 1988 grasshopper 1822D the engine shuts off when the pto is engaged does anyone have a wiring diagram for it i can only find one for the 1822K.

I have searched for hours but can't find the solution or anyone who has had this one yet.... I was mowing along and the Lazer Z HP died (engine quit). It will restart, but as soon as I release the parking brake the engine quits again. I've looked everything over: 1. two fuses good 2. Control...