Search Results for ‘ignition’

Hello everyone, I’m looking for some assistance with my Echo SHC-212 hedge trimmer. It’s used often, and it’s worked well until recently. About a week ago, I had some difficulty restarting after refilling, but it finished the job. Today, I can’t start it at all. Gas is fresh and high...

Can anyone lead me in the right direction of what to check next? I bought this TimeCutter SS4235 and it ran fine when I bought it. Sat it in the garage for a week or so and now it won't start. I replaced the starter solenoid and ignition switch and still won't start. Here is a video of it. Any...

Did a few searches, but I can't be the only one with this issue. I have two mowers, both Toros. One is a 3000, the other is a grandstand. I have an ongoing issue where during mowing around trees the key falls out of the ignition. Resulting in a lost key. Which is very frustrating. Basically, the...

I have a Cub Cadet Zforce 44 zero turn that sat out over the winter. I have made sure the battery is good and fully charged, it has a new starter solenoid and have checked all connections. When I turn the key to "on" I get no click like I used to and then when I try to start, nothing at all...

Hello from Northeast Mississippi, Newbie here so please be gentle. I have conducted searches but can't find anything on here that pertains to my problem, so any and all help/suggestions/recommendations are very much appreciated. I have a older eXmark Lazer Z with a Kohler Command Pro 23 engine...

Hi - I am looking for troubleshooting guidance for a walk-behind brush cutter (15-20 year old DR) with a Kawasaki FC420V AS-22 engine[1]. I'm not experienced with small engine repair or diagnostics, but I'm trying to learn. So I've probably checked some things that don't need checking, and...

I am in dire need of assistance. I have this Cub Cadet 1862 with the Kohler m18 engine and it turns over but no spark...I have already replaced the ignition module to no avail. Can anyone guide me in how to find out what the issue is....I am not happy since I had to remove the entire engine to...

Alright Gents, This problem is beginning to drive me a little nuts. This past fall the walker began to get a little difficult to get started. I would put the key in the ignition and turn it on and no power to the dash; no oil temp or pressure and no beep. I would turn it on and off a few...

I have a Bobcat Textron 60" deck with a 23HP Kawasaki with 525 hrs with multiple, I suspect related problems. The initial problem was that when turning the key, the starter would not engage...no click...no clunk...nothing. However, I could jump the solenoid posts and the starter would crank and...

Hi folks, I have just picked up what I think is a 1960's Cushman truckster. I has a ram on the back a PTO and a 18hp pmc 2 cylinder. 3 forward, reverse and a hi lo gears. It was running when I bought it however it just died all of a suden and refuses to start a friend of mine checked the...