Lawn Care Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-11 of 11 Results
  1. Mechanic and Repair
    I am a novice repairman, like to tinker. I acquired a Bunton 36 with subject engine from friend who thought the engine was blown. The shaft was seized and he could not pull start it. I started my repair by attempting to remove the pulley from the shaft and lo and behold the shaft freed up. I...
  2. Mechanic and Repair
    i have a exmark turftracer, with kaw fh541 and have an oil leak. seems to be coming out to right of where muffler attaches, lot on the bolt. i am some what mechanically inclined, but not sure what or where this is coming from. i would like to order parts and have everythang i need here before...
  3. Mechanic and Repair
    the Kawasaki FS481V on my eXmark metro is having issues. A month ago she kept flooding out on low speed and choking/surging on high speed. I ran it perfectly fine just two days before these issues. The float chamber was clean as a whistle which surprised me after six and a half years but I guess...
  4. Mechanic and Repair
    I have a 2013 scag tiger cat with a 27hp kohler command pro. It has been using oil really bad and I can't pin point where it's coming from. Valve cover gaskets looked good but oil is all over the main frame. Where do I start? Please help!
  5. Mechanic and Repair
    Hello from Indiana! I'm quite new here but have been reading for days on scag tiger cub issues. I recently acquired a 2005 Scag Tiger Cub. The previous owner says the exhaust cause some tall grass on fire which then caught the motor on fire. The motor has a severe oil leak (Kawasaki...
  6. Mechanic and Repair
    I have a Fr691v kawi that has just under 200 hrs on it and I'm having to put oil in it about every other week... No signs of leakage out of the drain plug or oil filter...confused I'm running 10w40 penzoil, correct oil filter, I try to keep this mower running top notch, I change everything at...
  7. Mechanic and Repair
    Have Kohler 27hp motor with 1500 hrs. Have oil leak, cleaned engine and it seems to be coming out of base of dip stick.... Any one now were to start?
  8. Mechanic and Repair
    i have a fh680v. not sure of orig hours. gov shaft oil leaking. simple enough, right then. 30 minutes later job done. the next day I noticed it was still leaking so I replaced again and its leaking again. I made sure all the mating surfaces were clean, oiled up the seal, then slid the seal...
  9. Mechanic and Repair
    Hi, Cannot fix oil leak. Started with a rocker arm backing off, thought it was a head gasket. Opened it up and found the rocker arm, put it back and running good. The oil leak started then, thought I had not sealed the valve cover. Went back in and ensured that valve cover was sealed...
  10. Lawn Mowing
    I have some confusion, I did a compression test on this engine that is blowing alittle oil thru the muffler. On the good side...ie clean side is 78-80 on the side showing the oil it's 95 or so. Does this sound like a valve or a ring? Thanks for any input.:hammerhead:
  11. Mechanic and Repair
    Just bought a brand new kubota GR 2110 along with 54"mower deck and snowblower. Tractor has 1 hr on the meter. Yes, I have contacted the dealer but I need independant advice from the experienced, here. Problem: The tractor was delivered in my garage which has a new cement floor. I noticed the...
1-11 of 11 Results
Top