Lawn Care Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. Mechanic and Repair
    I just bought a vantage with 1021 hours used. When the speed lever is half way up the mower will pull to the left. But when it is set all the way up it pulls to the right. And when the speed lever is set to N the mower creeps back. Any help is greatly appreciated!!
  2. Mechanic and Repair
    Hey, everyone! Title says it all. I feel like my 60 inch Lazer Z E-Series turning sensitivity is a little too stiff. Is there any way to adjust this? I don’t think there is air in the lines. We’ve already changed the hydro filter and oil a couple of times. Levels are correct. Thanks!
  3. Mechanic and Repair
    My 04 Scag cub started vibrating a few years ago when I was in forward throttle going up a hill. It has had a hydraulic leak for a long time. I just keep replacing the fluid and make sure it is full every time before I mow. When it happened the first time, I just replaced the fluid and...
  4. Mechanic and Repair
    We just picked up a used Exmark Navigator (600 hrs) to help with Fall Clean ups and use as a dedicated bagger. We run several mid mount commercial zero turns but we are new to this style mower. The issue is we can not get it to track straight. I have adjusted the tracking rods but still have...
  5. Lawn Mowing
    I've been looking for a while to buy a good used Scag. I finally located one that I think is a pretty good buy. It's an '02 (possibly '03) Tiger Cat with a 61" deck and 23hp Kohler. It's been kept inside a climate-controlled shop building and was used to mow a 3-acre lot. It looks like it's...
1-5 of 5 Results
Top