• Landscape Lighting Design: Bright Ideas
    With outdoor spaces more popular than ever, lighting these landscapes may be your next opportunity. Click here to learn more.

11hp. Briggs Carb. rebuild?????

T

troblandscape

Guest
Ok I have a late 80's Little wonder push blower, it has a 11hp I/C engine on it, I got a rebuild kit for it and it came with two of the valves for the float.... this is confusing me, one is larger than the other. I have now rebuilt the card about 8 times today and cannot get it to run,......... does anybody have a diagram or good advice about the two valves?? Thanx:confused: :confused:
 
T

troblandscape

Guest
Originally posted by troblandscape
Ok I have a late 80's Little wonder push blower, it has a 11hp I/C engine on it, I got a rebuild kit for the carb. and it came with two valves for the float.... this is confusing me, one is larger than the other. I have now rebuilt the carb about 8 times today and cannot get it to run,......... does anybody have a diagram or good advice about the two valves?? Thanx:confused: :confused:
btw I have only been using the larger valve, and am not sure where the smaller on goes
 

ducky1

LawnSite Senior Member
Location
s.e. Kansas
If your carb has a brass seat,use the rubber tipped valve. If your car has a brass seat with a rubber looking piece inside for the valve to seat against, use the all metal valve. You should have a viton seat in your kit if this is the carb that you have.
 
Top