Lawn Care Forum banner
1 - 5 of 5 Posts
G

·
Discussion Starter · #1 ·
I am needing info on changing ring and pinion on 14blt.10.5 gear. was wondering how complicated it is to switch from diff.to diff.and if the pinion comes out of the housing intact with the bearing's I have looked for this info in chilton's and haynes but could not find. Thanks CNO

Edited by: CNO
 
G

·
Discussion Starter · #3 ·
73 gmc all 14 bolt 10.5 ring gear's should be the same to my understanding.it has 410 ratio.
 

·
Registered
Joined
·
2,555 Posts
If you've never done this,expect a lot of swearing.the carrier is a slight press fit-if the bearings are good.So when you try to put it back in with the shims-it will be a pain without the case spreader tool.It can be done,but its best left to the pro's unless your willing to live with gear whine when your done-good luck

----------
John D
 

·
Registered
Joined
·
216 Posts
OK. On 73 it’s not the same as some of the older or heavier stuff. I would listen to John on this one. If you have never done it. It will give you nothing but problems. I recommend finding a good ring & pinion shop.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top