36" Wright Stander Striping Option?

Discussion in 'Lawn Mowing' started by Strawbridge Lawn, May 11, 2003.

  1. Strawbridge Lawn

    Strawbridge Lawn LawnSite Senior Member
    Messages: 660

    Anyone know of an option or way to add a striping flap or roller to one of these. I am used to rollers and frankly, a mower without some striping option don't stripe worth a hoot.
    One idea I had was to remove the wheelie rollers in back and suspend some type of device from a threaded 18" rod which would go through the existing holes (between thr rear wheels).
    Thoughts or solutions appreciated.
    Wright manufacturing...Where is your solution??
  2. Jusmowin

    Jusmowin LawnSite Senior Member
    Messages: 727

    STRAWBRIDGE, give me a call I have an idea for a striping kit that works good and only cost about $20 to make!
  3. UGA

    UGA LawnSite Senior Member
    Messages: 326

    It cost about $75 but most of that was for the welder.


Share This Page