1. Can’t make it to the GIE+EXPO 2017?
    LawnSite brings the trade show floor to your fingertips with our new GIE+EXPO 2017 Sneak Peek video series debuting now in the Lawn Mowing forum.

    Dismiss Notice

Accelerator Aluminum Grass/Leaf Catcher. Will need some welding

Discussion in 'Marketplace' started by davidcalhoun, Oct 9, 2012.

  1. davidcalhoun

    davidcalhoun LawnSite Bronze Member
    Messages: 1,045

    Hi, I need to thin the garage of some projects from several years ago. Back then, I got a Lesco 48" Commercialplus mower that came with this catcher on it. The catcher has just been sitting in my workshop and it's time to sell it to someone who can use it.

    This catcher will need some aluminum straightened and the welds redone and it should be just fine. See pics.

    $140 buys it. Local pickup is preferred at Granger, IN 46530. Yes, I will ship it if buyer pays for boxing and shipping cost.

    P1000919.jpg

    P1000920.jpg
     
  2. TinMan1

    TinMan1 LawnSite Senior Member
    from SC
    Messages: 518

    any idea if it will fit a 36"
     
  3. davidcalhoun

    davidcalhoun LawnSite Bronze Member
    Messages: 1,045

    No, I do not know. You might call Accelerator and ask them. If it does not, It may just take a different bracket than the one that came off of the Lesco mower.


    Note: The bracket that was on the Lesco comes with this catcher.
     
  4. travisn1

    travisn1 LawnSite Member
    Messages: 2

    Which size capacity is this? The 4.15 cu ft?
     
  5. davidcalhoun

    davidcalhoun LawnSite Bronze Member
    Messages: 1,045

    Yes, I believe it is the standard size.
     
  6. travisn1

    travisn1 LawnSite Member
    Messages: 2

    Is there a way i can contact you to get more details? I was unable to send a private message or e-mail. It may be because i just registered a new username...I have some interest in discussing further.
     
  7. davidcalhoun

    davidcalhoun LawnSite Bronze Member
    Messages: 1,045

    Since you can not PM yet, the best way would be to post your number here and I call you.
     
  8. PeterA

    PeterA Sponsor
    Messages: 543

    This is a 4.15 catcher for a Lesco mower. It would fit Scag advantage decks fairly well, as long as one was not mowing at a low height (it will ride about a 1/2 inch lower than the catcher we make for the scag advantage deck).

    It would not work at all for an exmark or toro mower.
     
  9. davidcalhoun

    davidcalhoun LawnSite Bronze Member
    Messages: 1,045

    Thanks Peter.

    I am sure your reply will answer several questions.
     
  10. davidcalhoun

    davidcalhoun LawnSite Bronze Member
    Messages: 1,045

    Bump for the weekend
     

Share This Page