anyone using a Kubota W5021 walk behind mower?

Discussion in 'Lawn Mowing' started by _CY_, Mar 27, 2009.

  1. fumblefingers

    fumblefingers LawnSite Member
    Messages: 55

    I want to set the throttle lever in the proper position. Please put your mower in the run position and let me know where the 8mm linkage nut is in in the slide position. The nut I am referring to is best seen in picture 1
     
  2. fumblefingers

    fumblefingers LawnSite Member
    Messages: 55

    [​IMG]Top view with air filter out
     
  3. cs9530

    cs9530 LawnSite Member
    Messages: 12

    Here are pages 93 and 105 - hope this helps...
     

    Attached Files:

  4. fumblefingers

    fumblefingers LawnSite Member
    Messages: 55

    Thanks a lot. I also see page 51 is mentioned about the blade clutch. Could you add.
     
  5. treysoucie

    treysoucie LawnSite Member
    from houston
    Messages: 126

    OK I'll snap a pic of the linkage in choke, low throttle and high throttle
    Posted via Mobile Device
     
  6. treysoucie

    treysoucie LawnSite Member
    from houston
    Messages: 126

    My non self propelled bogs down and dies if I apply the clutch too fast. If I apply the clutch very slowly it stays running. I may need to rip the clutch apart and check for corrosion or improper bearing wear
    Posted via Mobile Device
     
  7. fumblefingers

    fumblefingers LawnSite Member
    Messages: 55

    I pulled the carb and cleaned again. This time I pulled the pilot jet and sprayed the hell out of it because I did not have a tiny wire. Then I put carb back, put the throttle in run and pulled the starter. the mower started and ran for15 seconds then ran out of gas (empty tank):0
    It is too ot to mess with this any more today :)
     
  8. cs9530

    cs9530 LawnSite Member
    Messages: 12

    Here's page 51.
     

    Attached Files:

  9. treysoucie

    treysoucie LawnSite Member
    from houston
    Messages: 126

    Sounds promising. Usually when people have starting and idling issues 9times out of ten it's the pilot that's gunked up.
    Posted via Mobile Device
     
  10. cs9530

    cs9530 LawnSite Member
    Messages: 12

    Here's the S.2 Mower Blade Clutch and Blade (all three pages).
     

    Attached Files:

Share This Page