Anyone with a Turf Tracer.

Discussion in 'Lawn Mowing' started by exmarkguy123, Jun 24, 2010.

  1. exmarkguy123

    exmarkguy123 LawnSite Member
    Messages: 41

    Hi everyone,
    I currently mow with an Exmark Turf Tracer and to be honest i'm not exactly sure what height is optimal for my properties. My question: What height setting should I mow at (what hole should i put the pin).:confused: Thanks!
     
  2. Hell on Blades

    Hell on Blades LawnSite Senior Member
    Messages: 513

    3" fourth hole down -- 1/2" move for each hole.

    If you look in your manual, it has the reorder part # for the deck sticker that outlines it.

    try 1-553049
     
  3. albhb3

    albhb3 LawnSite Senior Member
    Messages: 502

    we run 3 but they are all fert and irr.
     
  4. exmarkguy123

    exmarkguy123 LawnSite Member
    Messages: 41

    Great! Thank you so much! I had it on the fourth down, but was a little parenoid that it wasn't optimal.
     
  5. MileHigh

    MileHigh LawnSite Silver Member
    Messages: 2,466

    UMMMMMMMM

    It depends on the turf dude.

    All my properties are mowed at either at the 3rd or 4th pin sticking up.

    Last year one property I mowed on 2, and another on 5.
     
  6. 350yddr

    350yddr LawnSite Member
    Messages: 48

    Howdy neighbor,

    Yeah, we too run a eXmark TT. This season we're mulching and cutting 3 1/4" (5th hole). Last year we discharged all season at 3", with a power chute. Don't think there is any hard and fast rule about the setup, experiment and go with what looks best. Good luck.
     
  7. greenstar lawn

    greenstar lawn LawnSite Senior Member
    Messages: 648

    I try not to go any lower then the 4th one up but some customers want there grass short which bugs me so i go to a 3 but i have one guy that gets the last one which is a 7
     
  8. exmarkguy123

    exmarkguy123 LawnSite Member
    Messages: 41

    Thanks for the info! I really appreciate it.
     
  9. mowerbrad

    mowerbrad LawnSite Fanatic
    Messages: 6,268

    You are cutting pretty much the same grass types that I am....I would suggest cutting at around 3"....can't say for sure what hole that would be...but you should be able to figure it out.
     
  10. MileHigh

    MileHigh LawnSite Silver Member
    Messages: 2,466

    my tthp cuts best at 8.5psi in the tires as well as the deck pitch down 1/4 inch in the front.
     

Share This Page