Lawn Care Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
127 Posts
Discussion Starter · #1 ·
My auto trans pan doesn't match any of the drawings on Chuck's site. The pan is square, with the rear, passenger corner cut off - basically the same as the 350 drawing on Chuck's page, but the opposite rear corner cut off. This pan also has what seems to be a drain plug on the front edge, almost at a 45 degree angle up into the pan. Thanks for any help you can give me. (One of these days I'll actually crawl under there and get the numbers off of it.)
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top