1. Missed the live Ask the Expert event?
    Catch up on the conversation about fertilization strategies for success with the experts at Koch Turf & Ornamental in the Fertilizer Application forum .

    Dismiss Notice

Balancing Walker Blades - a Tip

Discussion in 'Magna-Matic' started by CQ_DX, May 18, 2011.

  1. CQ_DX

    CQ_DX LawnSite Member
    from MA
    Messages: 67

    Having just read another thread about balanced blades, I thought I'd toss in a tip I use with Walker Blades.

    These blades have a bolted-on hub trash cup. Ever think to check the cup's balance or do you just clean, sharpen, and balance the blade? Some LSCs leave the cup attached and sharpen with the right angle grinder.

    I always remove the cup, clean it (right angle grinder with a cup brush), and then check the balance. Since I've had the Magna-Matic balancer, it is amazing to see how poorly balanced almost all cups are. I take a black marker and mark the heavy end. Then when I am sharpening the blade, I leave one end of the blade a tiny bit heavier. Then I reattach the cup with the heavy end of the cup on the light side of the blade. For the odd cup whose balance is fine, I mark it as such on the surface of the cup which goes against the blade. Then the next time this cup and blade come back for service, I know all I have to do is make sure its blade is perfectly balanced.

    I recheck all blade & cup assemblies on the balancer and I'm almost always right on the money.

Share This Page