1. Missed the live Ask the Expert event?
    Catch up on the conversation with Ken Hutcheson, President of U.S. Lawns, in the Franchising forum.

    Dismiss Notice

Bearing removal

Discussion in 'Mechanic and Repair' started by anubis7273, Jun 17, 2007.

  1. anubis7273

    anubis7273 LawnSite Member
    Messages: 4

    OK, well I have another question. Does anyony know how to remove the bearings on the blade shaft for a Bobcat 48" Deck? I have tried a bearing tool from Craftsman and it bent it right away. Is this something that I should remove from the top of the deck? Thanks, Kevin
     
  2. Mark in MD

    Mark in MD LawnSite Senior Member
    Messages: 322

    I'm not sure from your post whether you want to remove the ball bearings, or the entire spindle.

    When the spindles wear out on my Bob-Cat, I just replace the entire spindle. You'll need a pulley puller first.

    I've read that Bob-Cat spindles are mounted with lock-tite at the factory. If you heat the bolts, it should loosen the lock-tite.
     

Share This Page