blades clang each other on GD super surfer

Discussion in 'Lawn Mowing' started by lawnchopper, Sep 24, 2005.

  1. lawnchopper

    lawnchopper LawnSite Member
    Messages: 211

    i put a differ set of blades on our surfer i when i started the ends starting to hit each other just slightly not the cutting edges but the ends makes a hell of a racket but doesnt seem to cause much harm just little scratches on them . The blades are not bent so something must be tweaked under there??? I cant really tell by looking underneath. It seems every 5-10 seconds they will clang a little ;)
  2. Nosmo

    Nosmo LawnSite Bronze Member
    Messages: 1,216

    I've had that happen too. If your shaft has blade adapters make sure the blade hole is centered on them. But I'd say one or all of the blades are just a tad too long. I believe I would pull them off , measure them, compare the lengths with the blades you replaced and grind off the excess if there is any.


Share This Page