1. Can’t make it to the GIE+EXPO 2017?
    LawnSite brings the trade show floor to your fingertips with our new GIE+EXPO 2017 Sneak Peek video series debuting now in the Lawn Mowing forum.

    Dismiss Notice

Blowing fuses...

Discussion in 'Trucks and Trailers' started by khutch, Nov 13, 2004.

  1. khutch

    khutch LawnSite Senior Member
    Messages: 495

    Everytime I turn truck lights on w/trailer lights hooked up, I blow the 10 amp tail light (and speedo light) fuse in truck (Toyo Tacoma) Easiest thing, of course, is not to turn the lights on. Aside from that, how do you trouble shoot something like this?
     
  2. tinman

    tinman LawnSite Bronze Member
    from ga
    Messages: 1,346

    Check for bare wires on the trailer connector & at the trailer lights. Hope that helps.
     
  3. Lovbcstiller

    Lovbcstiller LawnSite Member
    Messages: 21

    try replacing the both plug ends. Sometimes the female (truck end) gets junk up into it and corrondes the plug out.
     
  4. grass_cuttin_fool

    grass_cuttin_fool LawnSite Gold Member
    Messages: 3,526

    10 amp fuse sounds a little small for marker lights, It may be with the trailer lights an extra 6-9 lights it may be too much for a 10 amp fuse. Check the wiring and see if you have any bare wires where they pass through metal or down the frame channel, if you dont see any then maybe go to a 15 amp fuse and see if it helps. I wouldnt go over a 20 amp fuse
     

Share This Page