Lawn Care Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
949 Posts
Discussion Starter · #1 ·
I have an old dethatcher (don't know the make) but it has fixed teeth and they are all worn out, bent, and some missing. So I was thinking of replacing the whole assembly with bluebird's flail assembly but I need a couple measurements of a machine. First I am not sure what the difference is between the C-18 and P-18 as far as measurements go. The critical one I need is the inside width of the flail assembly housing. And also the shaft length.
I hope you can help and are not that confused.

Thanks
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top