1. Missed the live Ask the Expert event?
    Catch up on the conversation about enhanced efficiency fertilizers with the experts at Koch Turf & Ornamental in the Fertilizer Application forum .

    Dismiss Notice

Can't remove the tines on Honda FRC-800 Tiller

Discussion in 'Landscape Architecture and Design' started by icecat14, Jul 31, 2008.

  1. icecat14

    icecat14 LawnSite Member
    Messages: 5

    I am at a loss as to how to get the right tine assembly off the drive shaft of my tiller. I had minimal trouble removing the left side assembly, but after removing the bolts I can't get the assembly off the shaft. Any ideas?
     
  2. White Gardens

    White Gardens LawnSite Fanatic
    Messages: 6,776

    How old is the tiller. I don't know honda tillers, but with my ariens and gilson, I had to use penetrating oil, heat, long punch, and a hammer to beat it off the shaft. On my gilson, I was trying to replace the brass bushings, so all I had to do was get one side off and slide the shaft out of the housing.

    Are you just trying to remove the tines, or the whole mounting assembly that slides on the shaft??
     

Share This Page