1. Can’t make it to the GIE+EXPO 2017?
    LawnSite brings the trade show floor to your fingertips with our new GIE+EXPO 2017 Sneak Peek video series debuting now in the Lawn Mowing forum.

    Dismiss Notice

Changing Blades

Discussion in 'Mechanic and Repair' started by Supper Grassy, Jun 5, 2007.

  1. Supper Grassy

    Supper Grassy LawnSite Bronze Member
    Messages: 1,582

    Ok, I know how to change them
    the question is how do i get the mower high enough or do u just raise it as high as i can

    i have a 36" snapper pro, residential use at this point
     
  2. MOW PRO LAWN SERVICE

    MOW PRO LAWN SERVICE LawnSite Bronze Member
    Messages: 1,568

    I use a jungle jack,they are expensive but they are used every day at the shop.
     
  3. Restrorob

    Restrorob LawnSite Fanatic
    Messages: 11,029

    On a unit that small you should be able to grab the front of the deck and lift it high enough to slide a jack stand under with your foot.

    Or set the jack stand in front of the unit and push down on the handle bar and roll it onto the stand.

    Or drive the front wheels up on some car ramps.
     
  4. Supper Grassy

    Supper Grassy LawnSite Bronze Member
    Messages: 1,582

    thanks you for the suggestions
     
  5. Mark in MD

    Mark in MD LawnSite Senior Member
    Messages: 322

    I'm not familiar with the Snapper Pro, but with my machines (Bobcats 32, 36, 48) with Kaw engines, I just grab them from the left side and flip them over onto their side 90 degrees. Carb up.
     

Share This Page